Experiencias de robótica imprimible en la Universidad

[track robotica]

En esta charla se mostrarán las experiencias educativas de robótica e impresoras 3D tenidas durante dos años en la Universidad Carlos III de Madrid con alumnos del Grado en Ingeniería Electrónica, Automática y Mecánica. Gracias a las impresoras 3D RepRap y a Arduino los estudiantes construyeron ellos mismos una gran variedad de robots imprimbiles, desarrollando su creatividad, y profundizando en sus conocimientos de mecánica, informática, electrónica, etc.

Ponente

My Name is Alberto Valero. I am an Engineer in Automation Engineering and Electronics from theEscuela Técnica Superior de Ingenieros Industriales de Madrid. I graduated in March 2004. I got myPhD at the Department of Computer Science and System Engineering (Dipartimento di Informatica e Sistemistica) at the “Sapienza” University of Rome. My advisors were Prof. Daniele Nardi and Prof. Fernando Matia. The title of the dissertation was: “Evolutionary Design of Human-Robot Interfaces for Teaming Humans and Robots in Exploration Missions”
From September 2008 until August 2010 I did my research in the Intelligent Control Group, Universidad Politecnica de Madrid, Spain, under the supervision of Prof. Diego Rodriguez-Losada and in collaboration with Ing. Paloma de la Puente. From September 2010 to December 2012 I have been visiting professor at Universidad Carlos III de Madrid, in “Departamento de Ingeniería de Sistemas y Automática”. From the 1st December 2012 to September 2013 I worked at BitBrain Technologies. At September 2013 I was hired by bq for leading the educational robotics group.